Skip to main content

Fix Bald Patches in Your Grass

Todays blog is about fixing bald patches in your grass.  I have an eight month old Cocker Spaniel who is causing yellow and bald spots in my lawn.  There are a few easy steps to fix this and is fairly inexpensive.   You could by some turf and cut out the affected area, however you need to replace a larger area and the grass may be a different colour.  Another reason I wouldn't use  turf for this is that it tends to dry out quickly and die off.

This is what the affected areas looked like...



I am not being sponsored for any of the products or by any of the businesses I mention during the blog. These are all products and businesses I use.

Here is my preferred method

1. Stuff Required (all available from B&Q)

  1. Aerator (or anything for making holes in the affected area such as a gardening fork) £15
  2. Small lawn rake or small fork £3
  3. Small box of grass seed £6.50
  4. Pre turf & lawn seed fertiliser £6.11 
  5. Dirt from the garden (preferred) of a small bag of compost

2. Preparation

  1. Using the small lawn rake or the small fork, rake out all the dead grass, thatch, moss etc.  you will need to be a bit aggressive with this to get down to bare soil.  You need to do this to allow the grass seed to germinate. 
  2. Aerate the affected area. This just means make some holes in and around the affected area. This should be to a minimum depth of around 3 inches (75cm approx).  This will allow air and water into the roots of the surrounding grass as well as allowing soil/compost to fall down to allow new root to grow.
  3. Scatter a handful of seed fertiliser over the area, ensuring that some fall into the holes you have made.
  4. Make sure the soil in the area is loose (not compacted) and apply a handful of grass seed spreading evenly.  Do not over-seed the area. Again make sure that some of the seed falls into the holes.

  5. Take some soil/compost and place over the grass seed and using your hand spread the soil over the area until it is level with the surrounding area and you start to see some grass seeds appearing. Yet again make sure that you push the soil/compost into the holes

  6. Water the area well.  Do not let the area get dry.  The seed will grow quicker of there is heat, sun and moisture.  There is a lot of debate around when you should water grass.  My preference would be in the morning as any overwatering should evaporate during the day. Try not to walk on the treated area with the new seed is growing
Here is the end result after around a month
Hope this helps.  Please leave a comment to let me know how you get on.
You can also find and follow me on Instagram - @beezersdiyhut • Instagram photos and videos
Thanks for reading...More DIY Blogs soon



Comments

  1. I'll need to give this a go! Thanks for posting

    ReplyDelete

Post a Comment

Popular posts from this blog

Deck Oil Vs Deck Stain?

What a good question this is!  Over the years I have used Decking stain on my now 19 year old, 40 square metre deck.  This year (2021) my deck has looked really old and in need of attention.  This is due to several reasons which include two really hard winters and the fact that I failed to treat the deck last year (2020) due to lack of products caused by the Pandemic. After reading several posts and watching several YouTube channels I decided to opt for the Decking Oil.  Just to let you know I am not being sponsored for any of the products below.  These are the products and ranges I personally use. After exploring the reviews of each of the products, I chose Screwfix's No Nonsense Decking Oil (this is a range I use frequently as it is great value for money and does exactly what it says on the tin....sorry for using Ronseal's phrase!).  £24.99 for 5 litres (sometimes they have this on offer) The reason for opting for this was that the Deck Oil was that it was quoted as it helps

Cleaning Shower Tray Sealant/Mastic

Revive your Shower Sealant In this short life hack I am going to demonstrate how you can clean your shower tray sealant/mastic without having to remove and re-seal at a very low cost. The whole process should take around 12 hours, however you will only be working for around 10 minutes! This is such a simple way and cost effective way of reviving your sealant. This blog has not been sponsored in any way. The products I have shared are the ones that I have used and preferred. Here goes…….. Before Step 1 – Items Required 1. The cheapest household bleach you can find! TescoThick Bleach Citrus 750Ml - Tesco Groceries 2. Rubber/disposable gloves (as you are dealing with bleach) Tesco Dishwashing Rubber Gloves Medium - Tesco Groceries 3. Eye protection (prevent bleach getting in your eyes) Site 2101 Origin Clear Lens Safety Specs | Safety Glasses | Screwfix.com 4. Old clothes (I have ruined several tee-shirts doing this!) 5. Cheap

New Life to Old Boots

This is a quick hack to show how to revive old leather boots.  My Timberland boots were looking a little washed out and worse for wear. After looking on the internet and a visit to my local Timpson's (Cobbler chain) I found a really good way to bring my boots back to nearly new (in my opinion anyway!).    This is what my boots looked like at the start.....   I  h ave not been sponsored for this blog and the materials used were either suggested on the Internet or by my local Timpson's shop. Step 1 - Materials Cloth (my preference was a non-branded microfibre, however the traditional yellow duster or soft cloth is fine) Cherry Blossom Mid Brown Renovating Shoe Polish £4.25, however this is a lot cheaper online.  Please get the colour that is closest to your boots. Timpson's Cobbler's Cream £5.25 Soft Bristle Brush . £1.00. I used an Ikea dish brush Squirt of Washing Up Liquid. Step 2 - Clean the Boots/Shoes Remove laces from the boots/shoes Clean the leather with some w